Banchory · Aberdeenshire · AB postcodes
Timber Back Doors in Banchory
Homes in Banchory get Timber Back Doors built around the opening they have, with the timber and finish specified against local conditions.
Specifying a door for Banchory
Banchory is an exposed inland location, taking wind-driven rain off higher ground. The load on a door here is water forced against the joints rather than salt, so the priority is shedding water away from the bottom rail and keeping the coating film intact.
Housing in and around Banchory is largely Victorian terraced and villa stock, which suits four-panel doors with a bolection moulding and an etched or obscured upper light. We match the mouldings and panel proportions to what is already on the street rather than fitting a generic pattern.
- Exposure
- Highly exposed — AB postcode area
- Timber
- Accoya or engineered redwood with a high-build coating
- Weather detail
- a storm-rated weatherbar, deep drip mould and a rebated hardwood cill
- Ironmongery
- Stainless or hot-dip galvanised fixings
- Recoating
- Every three to five years on the weather elevation
Planning note. Banchory has designated conservation areas and a number of listed frontages. Conservation status can remove permitted development rights on front elevations, and an Article 4 direction can tighten that further. Replacing like-for-like in timber is rarely a problem; changing the material or the glazing pattern usually is. We produce the elevations, sections and written specification a planning or listed building consent application needs. Check with Aberdeenshire planning before ordering.
Price and lead time in Banchory
Timber Back Doors start at £1,100 per door supplied and fitted, VAT included. Typical lead time is 5–7 weeks from survey. Use the indicative price tool for a range in about a minute.
Common questions
Does a back door need the same specification as the front?
Usually more. Back doors are often on the weather side, get harder use and see wetter conditions from the garden.
Do I need permission to change a door in a conservation area?
Often. Conservation area status can remove permitted development rights for front elevations, and Article 4 directions tighten it further. Check with the local planning authority before ordering.
Can modern sealed units go in a heritage door?
Slim-profile units down to around 11mm can, and they are frequently accepted where a chunky modern unit would not be. Some listed buildings still require single glazing.
What door suits a Victorian terrace?
A four-panel door with a bolection moulding and an etched or obscured upper light. Stile widths matter — narrow modern stiles make the proportions look wrong immediately.
How long does a made-to-measure timber door take?
Most doors run six to ten weeks from survey to fitting, depending on the specification and the finish. Repairs and re-hangs are usually inside three weeks. We confirm dates at survey rather than guessing at enquiry stage.
Will a timber door swell and stick?
Timber moves with humidity, which is why clearances, sealed end grain and a breathable finish matter. A door made to the correct moisture content and finished on all six faces stays workable through the seasons.
Nearby
We cover the rest of Aberdeenshire too.
Get a fixed price for Banchory
Send sizes or a photograph and we will come back with an indicative range, then survey free of charge before anything is made.