Stirling · Stirlingshire · FK postcodes
Timber Sliding Patio Doors in Stirling
We make and fit Timber Sliding Patio Doors throughout Stirling — measured properly, built from timber chosen for the exposure, and adjusted once they are in.
Specifying a door for Stirling
Stirling is an exposed inland location, taking wind-driven rain off higher ground. The load on a door here is water forced against the joints rather than salt, so the priority is shedding water away from the bottom rail and keeping the coating film intact.
Housing in and around Stirling is largely Victorian terraced and villa stock, which suits four-panel doors with a bolection moulding and an etched or obscured upper light. We match the mouldings and panel proportions to what is already on the street rather than fitting a generic pattern.
- Exposure
- Highly exposed — FK postcode area
- Timber
- Accoya or engineered redwood with a high-build coating
- Weather detail
- a storm-rated weatherbar, deep drip mould and a rebated hardwood cill
- Ironmongery
- Stainless or hot-dip galvanised fixings
- Recoating
- Every three to five years on the weather elevation
Planning note. Stirling has designated conservation areas and a number of listed frontages. Conservation status can remove permitted development rights on front elevations, and an Article 4 direction can tighten that further. Replacing like-for-like in timber is rarely a problem; changing the material or the glazing pattern usually is. We produce the elevations, sections and written specification a planning or listed building consent application needs. Check with Stirlingshire planning before ordering.
Price and lead time in Stirling
Timber Sliding Patio Doors start at £4,200 per set supplied and fitted, VAT included. Typical lead time is 10–12 weeks from survey. Use the indicative price tool for a range in about a minute.
Common questions
What is lift-and-slide?
Turning the handle lifts the sash off its seals onto rollers, so it glides. Releasing it drops the sash back down and compresses the seals, which is why it holds weather far better than a simple slider.
What drawings will I need for an application?
Usually an elevation at 1:20, a section through the door and frame showing mouldings, and a written specification of timber, finish and glazing. We produce these.
What do conservation officers usually object to?
Wrong material, wrong glazing pattern, and mouldings that are close but not right. Timber matching the original pattern is rarely refused.
What door suits a Victorian terrace?
A four-panel door with a bolection moulding and an etched or obscured upper light. Stile widths matter — narrow modern stiles make the proportions look wrong immediately.
What timber do you use?
Engineered redwood for painted doors, dense hardwoods such as sapele or idigbo where more strength is wanted, European oak where the grain is the point, and Accoya on exposed and coastal openings.
Can you match an existing door?
Yes. We take the mouldings, panel proportions and glazing pattern from the original and reproduce them. If the door is beyond saving we can still copy it before it goes.
Nearby
We cover the rest of Stirlingshire too.
Get a fixed price for Stirling
Send sizes or a photograph and we will come back with an indicative range, then survey free of charge before anything is made.