Pitlochry · Perth and Kinross · PH postcodes
Cottage Timber Doors in Pitlochry
Cottage Timber Doors made to measure for homes across Pitlochry, surveyed on site and finished in the workshop before they are hung.
Specifying a door for Pitlochry
Pitlochry is an exposed inland location, taking wind-driven rain off higher ground. The load on a door here is water forced against the joints rather than salt, so the priority is shedding water away from the bottom rail and keeping the coating film intact.
Housing in and around Pitlochry is largely stone and rendered cottage stock, which suits ledged, braced and boarded doors with a plank face and long strap hinges. We match the mouldings and panel proportions to what is already on the street rather than fitting a generic pattern.
- Exposure
- Highly exposed — PH postcode area
- Timber
- Accoya or engineered redwood with a high-build coating
- Weather detail
- a storm-rated weatherbar, deep drip mould and a rebated hardwood cill
- Ironmongery
- Stainless or hot-dip galvanised fixings
- Recoating
- Every three to five years on the weather elevation
Planning note. Pitlochry has designated conservation areas and a number of listed frontages. Conservation status can remove permitted development rights on front elevations, and an Article 4 direction can tighten that further. Replacing like-for-like in timber is rarely a problem; changing the material or the glazing pattern usually is. We produce the elevations, sections and written specification a planning or listed building consent application needs. Check with Perth and Kinross planning before ordering.
Price and lead time in Pitlochry
Cottage Timber Doors start at £1,250 per door supplied and fitted, VAT included. Typical lead time is 6–8 weeks from survey. Use the indicative price tool for a range in about a minute.
Common questions
What is a ledged and braced door?
Vertical boards held by horizontal ledges with diagonal braces running from the bottom hinge corner upward, which stops the door dropping. The brace must run the right way or it does nothing.
Do I need permission to change a door in a conservation area?
Often. Conservation area status can remove permitted development rights for front elevations, and Article 4 directions tighten it further. Check with the local planning authority before ordering.
Can modern sealed units go in a heritage door?
Slim-profile units down to around 11mm can, and they are frequently accepted where a chunky modern unit would not be. Some listed buildings still require single glazing.
What door suits a stone cottage?
A ledged, braced and boarded door with long strap hinges. Openings are usually low and rarely square, so the door is made to the opening as found.
Can you work to an architect's specification?
Yes. Send the drawings and schedule and we will price against them, flagging anything that will not perform as drawn.
How wide can a single door be?
Around 1,100mm for a standard leaf before the weight starts to work against the hinges. Beyond that a pair or a leaf-and-a-half arrangement is the sensible answer.
Nearby
We cover the rest of Perth and Kinross too.
Get a fixed price for Pitlochry
Send sizes or a photograph and we will come back with an indicative range, then survey free of charge before anything is made.