Pitlochry · Perth and Kinross · PH postcodes
Internal Timber Doors in Pitlochry
Homes in Pitlochry get Internal Timber Doors built around the opening they have, with the timber and finish specified against local conditions.
Specifying a door for Pitlochry
Pitlochry is an exposed inland location, taking wind-driven rain off higher ground. The load on a door here is water forced against the joints rather than salt, so the priority is shedding water away from the bottom rail and keeping the coating film intact.
Housing in and around Pitlochry is largely stone and rendered cottage stock, which suits ledged, braced and boarded doors with a plank face and long strap hinges. We match the mouldings and panel proportions to what is already on the street rather than fitting a generic pattern.
- Exposure
- Highly exposed — PH postcode area
- Timber
- Accoya or engineered redwood with a high-build coating
- Weather detail
- a storm-rated weatherbar, deep drip mould and a rebated hardwood cill
- Ironmongery
- Stainless or hot-dip galvanised fixings
- Recoating
- Every three to five years on the weather elevation
Planning note. Pitlochry has designated conservation areas and a number of listed frontages. Conservation status can remove permitted development rights on front elevations, and an Article 4 direction can tighten that further. Replacing like-for-like in timber is rarely a problem; changing the material or the glazing pattern usually is. We produce the elevations, sections and written specification a planning or listed building consent application needs. Check with Perth and Kinross planning before ordering.
Price and lead time in Pitlochry
Internal Timber Doors start at £420 per door supplied and fitted, VAT included. Typical lead time is 3–5 weeks from survey. Use the indicative price tool for a range in about a minute.
Common questions
Do internal doors need to be the same throughout?
Consistency reads well, but the practical requirement is consistent height and ironmongery. Mixing styles between floors is common in older houses and looks intentional.
Do I need permission to change a door in a conservation area?
Often. Conservation area status can remove permitted development rights for front elevations, and Article 4 directions tighten it further. Check with the local planning authority before ordering.
Can modern sealed units go in a heritage door?
Slim-profile units down to around 11mm can, and they are frequently accepted where a chunky modern unit would not be. Some listed buildings still require single glazing.
What door suits a stone cottage?
A ledged, braced and boarded door with long strap hinges. Openings are usually low and rarely square, so the door is made to the opening as found.
Can you replace the frame as well as the door?
Yes, and often it is the better answer. A new leaf in a rotten frame will not seal properly however well the door itself is made.
Is timber a sustainable choice?
Responsibly sourced timber is the only mainstream door material that stores carbon rather than emitting it in manufacture, and a timber door can be repaired rather than replaced.
Nearby
We cover the rest of Perth and Kinross too.
Get a fixed price for Pitlochry
Send sizes or a photograph and we will come back with an indicative range, then survey free of charge before anything is made.