Hexham · Northumberland · NE postcodes
Timber Door Frames in Hexham
Timber Door Frames made to measure for homes across Hexham, surveyed on site and finished in the workshop before they are hung.
Specifying a door for Hexham
Hexham is an exposed inland location, taking wind-driven rain off higher ground. The load on a door here is water forced against the joints rather than salt, so the priority is shedding water away from the bottom rail and keeping the coating film intact.
Housing in and around Hexham is largely Victorian terraced and villa stock, which suits four-panel doors with a bolection moulding and an etched or obscured upper light. We match the mouldings and panel proportions to what is already on the street rather than fitting a generic pattern.
- Exposure
- Highly exposed — NE postcode area
- Timber
- Accoya or engineered redwood with a high-build coating
- Weather detail
- a storm-rated weatherbar, deep drip mould and a rebated hardwood cill
- Ironmongery
- Stainless or hot-dip galvanised fixings
- Recoating
- Every three to five years on the weather elevation
Planning note. Hexham has designated conservation areas and a number of listed frontages. Conservation status can remove permitted development rights on front elevations, and an Article 4 direction can tighten that further. Replacing like-for-like in timber is rarely a problem; changing the material or the glazing pattern usually is. We produce the elevations, sections and written specification a planning or listed building consent application needs. Check with Northumberland planning before ordering.
Price and lead time in Hexham
Timber Door Frames start at £480 per frame supplied and fitted, VAT included. Typical lead time is 4–6 weeks from survey. Use the indicative price tool for a range in about a minute.
Common questions
Should I replace the frame with the door?
If the frame has softened at the foot or the cill is shedding water inwards, yes. A new leaf will not fix a frame that has failed.
Can modern sealed units go in a heritage door?
Slim-profile units down to around 11mm can, and they are frequently accepted where a chunky modern unit would not be. Some listed buildings still require single glazing.
Do I need permission to change a door in a conservation area?
Often. Conservation area status can remove permitted development rights for front elevations, and Article 4 directions tighten it further. Check with the local planning authority before ordering.
What door suits a Victorian terrace?
A four-panel door with a bolection moulding and an etched or obscured upper light. Stile widths matter — narrow modern stiles make the proportions look wrong immediately.
What happens if the door needs adjusting later?
First-season adjustment is included. Timber settles, buildings move, and a small tweak after a winter is normal rather than a fault.
Can you replace the frame as well as the door?
Yes, and often it is the better answer. A new leaf in a rotten frame will not seal properly however well the door itself is made.
Nearby
We cover the rest of Northumberland too.
Get a fixed price for Hexham
Send sizes or a photograph and we will come back with an indicative range, then survey free of charge before anything is made.