Moffat · Dumfries and Galloway · DG postcodes
Timber Door Frames in Moffat
We make and fit Timber Door Frames throughout Moffat — measured properly, built from timber chosen for the exposure, and adjusted once they are in.
Specifying a door for Moffat
Moffat is an exposed inland location, taking wind-driven rain off higher ground. The load on a door here is water forced against the joints rather than salt, so the priority is shedding water away from the bottom rail and keeping the coating film intact.
Housing in and around Moffat is largely stone and rendered cottage stock, which suits ledged, braced and boarded doors with a plank face and long strap hinges. We match the mouldings and panel proportions to what is already on the street rather than fitting a generic pattern.
- Exposure
- Highly exposed — DG postcode area
- Timber
- Accoya or engineered redwood with a high-build coating
- Weather detail
- a storm-rated weatherbar, deep drip mould and a rebated hardwood cill
- Ironmongery
- Stainless or hot-dip galvanised fixings
- Recoating
- Every three to five years on the weather elevation
Planning note. Moffat has designated conservation areas and a number of listed frontages. Conservation status can remove permitted development rights on front elevations, and an Article 4 direction can tighten that further. Replacing like-for-like in timber is rarely a problem; changing the material or the glazing pattern usually is. We produce the elevations, sections and written specification a planning or listed building consent application needs. Check with Dumfries and Galloway planning before ordering.
Price and lead time in Moffat
Timber Door Frames start at £480 per frame supplied and fitted, VAT included. Typical lead time is 4–6 weeks from survey. Use the indicative price tool for a range in about a minute.
Common questions
Should I replace the frame with the door?
If the frame has softened at the foot or the cill is shedding water inwards, yes. A new leaf will not fix a frame that has failed.
What drawings will I need for an application?
Usually an elevation at 1:20, a section through the door and frame showing mouldings, and a written specification of timber, finish and glazing. We produce these.
What do conservation officers usually object to?
Wrong material, wrong glazing pattern, and mouldings that are close but not right. Timber matching the original pattern is rarely refused.
What door suits a stone cottage?
A ledged, braced and boarded door with long strap hinges. Openings are usually low and rarely square, so the door is made to the opening as found.
What about draughts around the frame?
Compression seals in the rebate handle the leaf; the gap between frame and structure is a separate job, insulated and sealed on fitting rather than filled with expanding foam alone.
Do you fit in winter?
Yes. Clearances are set for the season and the finish is already cured, so there is no waiting for weather to paint on site.
Nearby
We cover the rest of Dumfries and Galloway too.
Get a fixed price for Moffat
Send sizes or a photograph and we will come back with an indicative range, then survey free of charge before anything is made.